 Max Baldwin will send your site plan after you place your pergola order. You can use the plan to mark out the exact locations for the legs of your pergola. All measurements are to the centers of the posts. |
 Check your site to see if it is level. Use a laser level, which you can buy at any home center for around $40. If the patio isn't level, that's o.k. we will cut the pergolas legs to fit your patio. Just email the elevation of each post location to max@baldwinpergolas.com. |
 The posts come to you with a one inch thick, black plastic foot attached which will keep the end grain dry. It and the leg have been drilled with a one inch diameter bit to make room for the "Post Locating Pins". These pins need to be installed into your patio. To do this you must drill a hole through the pavers and hammer a piece of 1/2 inch re-bar into the Earth. Use a heavy hammer to drive the Post Locating Pins into the patio. |
 When complete the pin should extend three inches above the surface. |
|
|
Call us toll-free: 1-800-344-5103